Analysis of common faults of geared motors

1) Insufficient or excessive lubricating oil, according to the product operation manual, the oil product and the oil star breathable cap are not unscrewed.
2) Cycloid needle wheel reducer overcurrent protection or load overload, check the cause of overload of the gear motor, adjust to meet or replace the larger power gear motor
3) Before turning on the power, confirm the installation location of the ventilation cap, exhaust and heat dissipation.
4) Different installation methods have different stars for lubricating oil. After confirmation, add the specified oil stars to ensure the lubrication effect and heat dissipation effect.
2. Abnormal operating noise of gear motor
1) Rotation noise.
2) Percussion noise, irregular meshing.
3) When the lubricating oil has impurities or insufficient oil volume
Replace the lubricating oil or refuel to the specified value
3. When the motor rotates, the output shaft of the reducer does not rotate.
The key connection of the reducer is damaged or the transmission gear is worn out，
Disassemble, overhaul and replace parts.
Fourth, oil leakage
1) Adjust the lubricating oil level and oil volume；
2) The breathable cap is not installed correctly.
Confirm the position and direction of the vent cap, and make sure that the vent cap is above or above the lubricating oil.；
3) The oil seal or stuffy cover leaks oil, and the oil seal or stuffy cover is replaced when the oil seal or stuffy cover is aging or improperly installed.；
4) The gasket is damaged and aging, replace the gasket or O-ring.